Hi,
I've been using rescene to rescene .iso's. Unfortunately as you know many still fail. I want to check I am doing everything I can to rescene them.
i check the CRC's against srrdb.com to make sure the CRC's match first
1. I let it run all the way through with no special settings using all the final release rars from 2.00 - 5.40 (my iso's were normally created between about 2006 and 2014) It runs through all the rars twice. First run through takes a while, 2nd run through can take a couple of hours to 8+ hours.
2. I try again using just the beta rars from around the time the .iso was created.
If I get 'no good rar found' is there anything else I can try? I have tried using the —mt-set command as well but have never found a good rar when adding this setting. (If I got a ValueError: still not fine —mt-set has so far always fixed it)
Actually when it comes down to it pyReScene has either found a good rar within the first 5 it has tried in the first run through the rars or it has never found a good rar. Is there anything else I can try.
Thanks
P.S. on srrdb.com at the bottom of each release there is the box 'RAR Recovery' sometimes it says 'Not Present' and sometimes 'Present (Protect+)' are you able to explain these two possibilities? I couldn't find the info anywere on the internet.